Chapter Twelve Disassembly and Installation of Oil Pump and
Lubrication System
I. Disassembly Procedure
1. Roll over the engine and use a 10# sleeve to remove
the fixing bolt of oil pan.
Torque: 15+3 Nm
2. Use a screwdriver to pry out the oil pan at the given
position for prying out on the oil pan.
Note:
Because the oil pan and cylinder block are sealed
with glue, so, do not knock with such hard articles as
hammer etc. when disassembling, use a rubber hammer to
slowly strike at left and right instead.
3. Use a 10# sleeve to remove the fixing bolt of engine
oil strainer.
4. Use an 8# sleeve to remove the fixing bolt of engine
oil guard board.
