2.3.4 Detection of planeness of cylinder head
Follow the method as shown in the figure to
measure planeness of the cylinder head with a feeler
gauge; the planeness of the cylinder should not
exceed 0.05-0.10mm, if exceeding this valve,
replace the cylinder head assembly.
III. Assembly of Cylinder Head Assembly
1. Please follow the order adverse to that for
disassembly of cylinder head to install, but care
should be taken for the following matters during
installation.
2. Use the special tool CH-20012 to install new
valve oil seal onto the guide first.
3. Insert big end of the guide onto the valve guide.
4. Envelope the special tool onto CH-20012, and
then softly and forcibly compact.
