The cord reel cord shall terminate with a NEMA L14-30R, 30 amp twistlock female receptacle.
ELECTRICAL CORD JUNCTION BOX
Two Akron junction box, model EJB shall be provided. The junction box is to be powder coated
safety yellow and be provided with rubber feet on the bottom of the box.
Two yellow powder coated mounting brackets, model EJB-VMT is to be shipped loose with the
apparatus for final installation by the department.
The light box outlets are to be as follows:
The outlet in Location 1 is to be a
Single L14-30 125/250 Volt AC twist lock outlet with spring loaded cover.
The outlet in Location 2 is to be a
Duplex L5-15 125 Volt AC twist lock outlet with spring loaded cover.
The outlet in Location 3 is to be a
Duplex L5-15 125 Volt AC twist lock outlet with spring loaded cover.
The outlet in Location 4 is to be a
Duplex L5-15 125 Volt AC twist lock outlet with spring loaded cover.
REEL REWIND SWITCH
The cord reels shall be equipped with a weather resistant push button switch mounted in the relay
enclosure box within compartment that the reel is contained.
UTILITY AIR HOSE REEL
One (1) Hannay model EF1514-17-18 hose reel with electric rewind shall be provided center
ceiling mounted in the L3 compartment with operation primarily to the driver. The reel shall be
capable of holding at least one hundred fifty feet (150') of 3/8" utility air hose. An electrical rewind
switch shall be provided in the same compartment for the hose reel rewind. There shall be a 3/4"
line from the chassis air system connected to the hose reel for air supply. The reel shall be equipped
with one hundred fifty feet (150') of 3/8" air hose rated at 300 PSI. A ball stop shall be provided
and installed at the end of the air hose.
REFLECTIVE SAFETY STRIPE
A 2" reflective gold x 6" reflective white 3M brand Scotchlite reflective stripe shall be affixed to
the perimeter of the vehicle. The striping shall be placed up to 60" above ground level and shall
conform to NFPA reflectivity requirements. At least 60% of the perimeter length of each side and
width of the rear, and at least 25% of the perimeter width of the front of the vehicle shall have
reflective stripe.
BODY STRIPE "Z" PATTERN
The stripe on each side of the apparatus shall run straight back to the body, with a reverse "Z"
pattern shape on the front body door and then run straight back from there to the rear of the body.
