CUP HOLDERS
There shall be two (2) recess mounted cup holders mounted on top of the doghouse console.
MULTIPLEXED ELECTRICAL SYSTEM
The apparatus shall be equipped with a Class 1 ES-Key Management System for complete control
of the electrical system devices. This management system shall be capable of performing load
management functions, system monitoring and reporting, and be fully programmable for control of
the electrical system. NO Exceptions
The ES-Key system shall provide diagnostic capabilities for troubleshooting the electrical system
of the apparatus.
CHASSIS COLOR CODED WIRING
All chassis wiring shall be type "GXL" in accordance with S.A.E. J1128 and NFPA-1901. ALL
wiring shall be COLOR CODED and continuously marked with the circuit number and function.
All wiring to be covered in nylon heat resistant loom rated at a minimum of 300 degrees F
The chassis cab, engine and transmission, and body shall be electrically bonded to the chassis
frame rails with braided ground straps.
ELECTRICAL SYSTEM CONNECTORS
All multiple conductor electrical connections shall be made with Packard electrical connectors.
The Packard connectors shall become mechanically locked when mated. All single wire
terminations requiring special connectors with a ring or spade terminal shall be crimped, and
wrapped with heat shrink tubing.
INFORMATION DISPLAY MODULE
The Class -1 Information Display Module shall be located in the overhead panel for viewing by the
driver is for displaying text, warnings and diagnostics. The information Display Module shall allow
the Town to access and change load management shedding priority and provide maintenance text
listing the routine maintenance items and lubrication capacities on the apparatus.
BACKUP CAMERA
There shall be an ASA Audiovox video system provided on the apparatus. The color monitor shall
be an ASA AOM713WP. The monitor for the back-up camera shall be mounted on top of the
engine doghouse within view of the driver to aide in backing up the apparatus. The back up camera
system shall be powered with the ignition power in the cab. Operation of the camera will be by the
driver with the monitor controls.
REAR CAMERA - COLOR - HIGH PERFORMANCE
There shall be supplied a color, heavy duty high resolution observation camera, ASA Model
VCCS150. The camera shall have a non corrosive mounting bracket and stainless steel hardware.
The back up camera shall be mounted at the upper rear of the apparatus beneath the walkway.
A 12 gauge stainless steel trim guard shall be affixed to the wall behind the camera with a flange
over the top of the camera housing to aid in protecting the camera. The flange over the camera
shall be one inch wider than the camera width and extend one-half an inch behind the rear of the
camera face.
