Chapter 8 The VPN Transport Screens
User’s Guide
91
The following table describes the labels in this screen.
8.4.1 Ethernet Pseudowire Setup
Click a pseudowire entry’s Edit icon in the ADVANCED > VPN Transport > Ethernet
Pseudowire screen to set up or modify an Ethernet pseudowire’s configuration.
Figure 48 ADVANCED > VPN Transport > Ethernet Pseudowire Setup
The following table describes the labels in this screen.
Table 30 ADVANCED > VPN Transport > Ethernet Pseudowire
LABEL DESCRIPTION
# The number of the item in this list.
Active This icon is green if the associated pseudowire is enabled. The icon is grey
if the associated pseudowire is disabled. Enable or disable a pseudowire by
clicking its Edit icon.
MPLS VC Label
Ingress This is the MPLS virtual circuit label number for traffic coming from the peer
device.
Egress This is the MPLS virtual circuit label number for traffic going to the peer
device.
Pseudowire Description This displays the information you previously entered describing the
pseudowire.
Action Click the Edit icon to set up an Ethernet pseudowire or alter the
configuration of an existing Ethernet pseudowire.
Click the Delete icon to remove an existing Ethernet pseudowire.
Table 31 ADVANCED > VPN Transport > Ethernet Pseudowire Setup
LABEL DESCRIPTION
Active Select this to enable the pseudowire. Deselect it to disable the
pseudowire.
MPLS VC Label
Ingress Enter the VC ingress label number for this pseudowire. This must be the
egress label number of the peer device. This should not be the ingress
label number of any other Ethernet pseudowire configured on the WiMAX
Modem.
