Chapter 8 The VPN Transport Screens
User’s Guide
89
8.3.4 Customer Interface Setup
Click the Edit icon in the ADVANCED > VPN Transport > Customer Interface screen to
open the Customer Interface Setup.
Customer interfaces map traffic onto specific Ethernet pseudowires for transport over the
WiMAX network. There is also a default customer interface for routing traffic that does not
possess a VLAN tag.
Figure 45 ADVANCED > VPN Transport > Customer Interface Setup
The following table describes the labels in this screen.
Table 28 ADVANCED > VPN Transport > Customer Interface Setup
LABEL DESCRIPTION
Active Select to make this customer interface active. Deselect it to make the
customer interface inactive.
Customer Interface
Type A customer interface can be tagged (controlling traffic that has a specific
VLAN ID) or untagged (controlling traffic without a specific VLAN ID). There
can be only one untagged interface.
VLAN ID Enter the Virtual Local Area Network Identifier number (1 ~ 4094) for this
interface. This VLAN ID must not be used by any other customer interface.
For the untagged interface, -1 displays.
Mode This displays Bridging or Routing. A tagged interface can operate in bridging
mode only.
Associated Ethernet
Pseudowire
Select the Ethernet pseudowire this interface should use for communications
over the WiMAX network. You should configure the pseudowire (in the
ADVANCED > VPN Transport > Ethernet Pseudowire screen) before you
select it.
DSCP If you wish to prioritize an interface, enter a DiffServ Code Point value of six
bits in binary notation. The higher the value, the higher the interface’s priority
on the WiMAX Modem’s WiMAX link.
Interface Description Enter a brief (up to 31 characters) name or description for this interface.
Apply Click to save your changes.
Cancel Click to return to the previous screen without saving your changes.
