Chapter 8 The VPN Transport Screens
User’s Guide
88
The following table describes the icons in this screen.
The following table describes the labels in this screen.
Table 26 Advanced> VPN Transport > Customer Interface
ICON DESCRIPTION
Edit
Click to edit this item.
Delete
Click to delete this item.
Table 27 ADVANCED > VPN Transport > Customer Interface
LABEL DESCRIPTION
# The number of the item in this list.
Active This icon is green if the associated interface is enabled. The icon is grey if the
associated interface is disabled. Enable or disable an interface by clicking its Edit
icon and selecting or deselecting Active and clicking Apply in the screen that
displays.
Interface
Type This displays either Tagged or Untagged. A tagged interface controls traffic with
a specific IEEE 802.1Q VLAN tag, whereas an untagged interface controls traffic
that does not have a VLAN tag. There can be only one untagged interface.
VLAN ID For a tagged interface, this displays the IEEE 802.1Q VLAN ID number. For the
untagged interface, -1 displays.
Mode This displays either B (bridging) or R (routing). Only the default interface,
interface 0, can be a routing interface.
Associated
Ethernet
Pseudowire
(Ingress, Egress)
This displays the number of the Ethernet pseudowire that this interface uses, as
well as the ingress and egress MPLS (Multi-Protocol Label Switching) VC (Virtual
Circuit) label numbers.
DSCP This displays the DiffServ Control Point value you previously entered in binary.
This determines the pseudowire’s priority on the network. The DSCP value is
displayed in binary notation and has six bits.
Interface
Description
This displays the information you previously entered describing the interface. For
the default interface, interface 0, the description reads “for routing / NAT”.
Action Click the Edit icon to set up a new interface or alter the configuration of an
existing interface.
Click the Delete icon to remove an existing interface.
