Dil ID: 8
Dil Adı: italy
Dil Kodu: it4tayfun Prodotti del Marchio Scion
Dünyanın En Büyük
Elektronik Bilgi Kütüphanesi



SCION tC 2007 SUPERCHARGER
Procedure
Page 4 of 36
Issue A: 04/10/07
Care must be taken when installing this accessory to ensure damage does not occur to the vehicle. The installation of this
accessory should follow approved guidelines to ensure a quality installation.
These guidelines can be found in the "Accessory Installation Practices" document.
This document covers such items as:-
Vehicle Protection (use of covers and blankets, cleaning chemicals, etc.).
Safety (eye protection, rechecking torque procedure, etc.).
Vehicle Disassembly/Reassembly (panel removal, part storage, etc.).
Electrical Component Disassembly/Reassembly (battery disconnection, connector removal, etc.).
Please see your Toyota dealer for a copy of this document.
1. Installation review and vehicle preparation.
(a) Review entire installation instructions provided
with this supercharger kit before beginning the
installation.
(b) Review parts list/kit contents to ensure that all
parts are present before beginning the
installation. If any items are missing contact
Technical Support at (800) 688-5912 before
proceeding.
(c) Remove any low-octane fuel from vehicle.
Ensure that ONLY 91 octane or higher
unleaded gasoline is used.
(d) Place vehicle onto vehicle hoist.
(e) Place fender protection blankets over fenders
and front of vehicle to protect cosmetics of
vehicle.
2. Coolant System Parts Removal & Installation.
(a) Disconnect battery negative terminal. 10mm
wrench. Then disconnect battery positive
terminal. Remove battery hold down strap.
Remove battery and plastic tray from engine
compartment. Caution: Batteries contain an
acid solution, be sure to wear eye protection
and gloves when handling the battery. Place
battery onto workbench until replacement later.
Do not place battery on cement or concrete
floors.
12 mm Wrench
Fi
g
. 1
10 mm Wrench