SCION tC 2007 SUPERCHARGER
Procedure
Page 6 of 36
Issue A: 04/10/07
3. Oil Pan Parts Removal & Replacement.
(a) Drain engine oil (14 mm wrench) into proper
receptacle The OE oil pan will be removed and
replaced with a TRD supplied oil pan after
draining.
(b)
Temporarily remove 2 exhaust bolts and let
exhaust pipe hang down low in order to gain
access to oil pan bolts. Fig. 7.
(c)
Remove the oil pan by removing the 12 bolts
and 2 nuts. Fig 8. Use
SST 09032-00100 to
remove pan from crankcase. See Figure 9.
Caution: Be careful not to damage the sealing
surface of the crankcase, chain cover, or oil
pan.
(d)
Carefully clean the mating surfaces on the
crankcase, chain cover and TRD supplied oil
pan.
(e)
Apply a continuous bead of 00295-00103
FIPG seal packing (3.0 to 4.0 mm in diameter)
to the sealing surface of the oil pan as shown in
Figure 10.
CAUTION: Remove ANY and
ALL oil residue from the sealing surfaces first.
Install the oil pan within 3 minutes of applying
sealant. Do
NOT put engine oil into the
engine for
at least 2 hours after installing the
oil pan.
(f)
Uniformly tighten the fasteners on the oil pan
in the sequence shown in Figure 8. Torque to
80 in-lbs.
(g)
Re-attach exhaust pipe, and re-install 2 exhaust
bolts removed previously.
Torque to 32 ft-
lbs. Install oil drain plug and new drain plug
gasket.
Torque plug to 30 ft-lbs. Clean off
any excess oil from engine, oil filter, pan and
exhaust. Replace oil filter as needed. Prime
new oil filter with SAE 5W-30.
Fi
. 8
Fi
. 9
Fi
. 10
Fi
. 7
14 m
