
SCION tC 2007 SUPERCHARGER
Preparation
Page 2 of 36
Issue A: 04/10/07
Additional Items Required For Installation
Item # Quantity Reqd. Description
1 Toyota Diagnostic
Scanner/Techstream
Diagnostic Tester/Scan
Tool
2 GR8 Battery Charger
Conflicts
TRD Strut Brace: PTR-02-21060
PTR-02-21070
TRD Cold Air Intake: PTR-03-21060
PTR-03-21070
Recommended Tools
Personal & Vehicle
Protection
Notes
Safety Glasses
Fender Blankets
Protective Gloves
Special Tools Notes
Serpentine Belt tool
SST 09249-63010
Fuel Supply Hose tool
SST 09268-21010
Crankshaft Pulley Holder
SST 09213-54015
Pulley Holder Lever Arm
SST 09330-00021
Gasket Seal Cutter
SST 09032-00100
Oil Filter Wrench
09228-06501 or equivalent
Installation Tools Notes
Mechanic’s Hand Tools Combo wrenches & sockets
Metric AND Standard
½” Drive Torque Wrench For crank pulley bolt install
19 mm 12-point socket ½”
drive
For crank pulley bolt install
Electric Drill and Drill Bits
Uni-Bit up to ½ “ diameter
Special Chemicals Notes
Anti-Seize Assembly Lube For Spark Plugs
Toyota Seal Packing (FIPG)
08826-00080 or 00295-
00102 or 00295-00103
Or equivalent for oil pan
reinstallation.
Loctite 242 Blue Or equivalent
Loctite 272 Red Or equivalent
Loctite 567PST Teflon Paste Or equivalent
General Applicability
(2007- ) Scion tC (2AZ motor)
Recommended Sequence of Application
Item # Accessory
1 R&R Thermostat
2 R&R Oil Pan
3 Remove Airbox Assy.
4 R&R Crank Bolt
5 Install Supercharger
6 Install Intake System
7 Re-Flash ECU w/ TRD Map
8 Test
*Mandatory
Vehicle Service Parts (required for reassembly)
Item # Quantity Reqd. Description
1 1 Oil Filter , 90915-YZZF1
2 1 Oil Drain Gasket 90430-12031
3 4.0 ~ 4.8 Quarts Oil, SAE 5W-30
4 1 roll Black Electrical Tape, 600 V
Legend
STOP: Damage to the vehicle may occur. Do not
proceed until process has been complied with.
OPERATOR SAFETY:
Use caution to avoid risk of
injury.
CAUTION:
A process that must be carefully observed
in order to reduce the risk of damage to the
accessory/vehicle and to ensure a quality installation.
TOOLS & EQUIPMENT:
Used in Figures calls out the
specific tools and equipment recommended for this
process.
REVISION MARK:
This mark highlights a change in
installation with respect to previous issue.