Prodotti del Marchio Scion

AEM Air Intake System Warranty Policy

AEM

warrants that its intake systems will last for the life of your vehicle. AEM will not honor this warranty due to mechani-

cal damage (i.e. improper installation or tment), damage from misuse, accidents or ying debris. AEM will not warrant

its powder coating if the nish has been cleaned with a hydrocarbon-based solvent. The powder coating should only be

cleaned with a mild soap and water solution. Proof of purchase of both the vehicle and AEM intake system is required for

redemption of a warranty claim.

This warranty is limited to the repair or replacement of the AEM part. In no event shall this warranty exceed the original

purchase price of the AEM part nor shall AEM be responsible for special, incidental or consequential damages or cost

incurred due to the failure of this product. Warranty claims to AEM must be transportation prepaid and accompanied with

dated proof of purchase. This warranty applies only to the original purchaser of product and is nontransferable. Improper

use or installation, use for racing, accident, abuse, unauthorized repairs or alterations voids this warranty. AEM disclaims

any liability for consequential damages due to breach of any written or implied warranty on all products manufactured by

AEM. Warranty returns will only be accepted by AEM when accompanied by a valid Return Merchandise Authorization

(RMA) number. Credit for defective products will be issued pending inspection. Product must be received by AEM within

30 days of the date RMA is issued.

If you have a warranty issue, please call (800) 992-3000 and our customer service department will assist you. A proof of

purchase is required for all AEM warranty claims.

For technical inquiries

e-mail us at

[email protected]

call us at

800.992.3000

10-7024D

03/14/14

4. Reassemble Vehicle

a. Position the intake pipes for the best tment. Be sure that the pipes or any other components do not contact any

part of the vehicle. Tighten the rubber mount, all bolts, and hose clamps.

b. Check for proper hood clearance. Re-adjust pipes if necessary and re-tighten them.

c. Inspect the engine bay for any loose tools and check that all fasteners that were moved or removed are properly

tightened.

d. Reconnect negative battery terminals and start engine. Let the vehicle idle for 3 minutes. Perform a nal inspection

before driving the vehicle.

NOTE: If vehicle was started without the VSV or the MAF sensor connected, the “Check Engine” light may

come on. If this happens turn the engine off and disconnect the battery for one minute. Reconnect the bat

tery and restart the engine.

e. Please note that AEM® bypass valves will not work with this application (part number 21-567). The use of a

bypass valve could have adverse effects on the performance of the system.

5. CARB Sticker Placement

a. The C.A.R.B. exemption sticker, (attached), must be visible under the hood so that an emissions inspector can see

it when the vehicle is required to be tested for emissions. California requires testing every two years, other state

may vary.

6. Service and Maintenance

a. It is recommended that you service your AEM

Dryow™ lter every 20,000 miles for optimum performance. Use

AEM Dryow cleaning kit part # 21-110.

b. Use aluminum polish to clean your polished AEM intake tube.

c. Use window cleaner to clean your powder coated AEM intake tube. (NOTE: DO NOT USE aluminum polish on

powder coated AEM intake tubes)

See aemintakes.com for CARB status on each part for a specific vehicle

LEGAL IN CALIFORNIA ONLY FOR RACING VEHICLES

WHICH MAY NEVER BE USED, REGISTERED

OR LICENSED FOR USE UPON A HIGHWAY.