8
p. Place a small screwdriver in the slot of the clip and
gently pry downwards. Split the housing of the clip
open. Slide the clip down the wire harness a couple
of convolutions to free up more harness towards the
MAF sensor. Repeat for the second wire harness clip.
Reinstall both clips to the bracket on the engine. Plug
in the MAF sensor wire harness and make sure the
wires are not stretched.
r. Clip the VSV on to the bracket. If the VSV does
not clip on tightly, gently bend the tab on the VSV to
increase the tension.
q. Install the VSV mounting bracket using one of the
factory air box bolts as shown.
Factory air box system installed AEM
®
intake system installed
