6
d. Install the supplied rubber mount bracket as shown
and secure the resistor ballast using the original bolts.
Install the supplied rubber mount using one fender
washer and one lock nut.
e. Loosely install the coupler onto the throttle body
using the two #36 hose clamps. Orient the nipple so
that it is pointed approximately 45° back towards the
rewall. This will be adjusted later in the installation.
f. Install the AEM
®
intake pipe from underneath the
vehicle. Insert the end near the MAF sensor into the
coupler on the throttle body. The mounting bracket on
the intake pipe should line up with the rubber mount
installed in step 3d.
g. Loosely secure the mounting bracket with the
remaining fender washer and lock nut. Refer to the
diagram below for proper rubber mount installation.
h. Install the AEM
®
air lter onto the end of the intake
pipe.
i. Rubber mounting bracket diagram.
