SCION xA 2004 − SECURITY WITH RKE (V3)
Section II − Installation Procedure
Page 11 of 23 pages Supplier Ref #: DIO
Issue: A 06/09/03
30. Route and secure the V3 harness to the vehicle
harness with one medium wire tie below the
steering column. (Fig. C−15)
31. Route and secure the V3 harness with the
black 4P connector to the vehicle harness with
two medium wire ties to the left of the steering
column. (Fig. C−16)
i. Ensure that these wire ties do NOT secure
the fog light switch harness.
D. Status Monitor Installation
1. Connect the V3 harness’ black 4P connector to
the status monitor. (Fig. D−1)
i. Verify the connectors are plugged in
securely.
2. Insert the status monitor into the knockout
opening in the dash cover. (Fig. D−1)
i. Verify the status monitor sits finish in the
cover.
3. Secure the V3 harness to the vehicle harness
with one medium wire tie. (Fig. D−1)
Fig. C−15
Medium Wire Tie
V3 Harness
Side Cutter
Fig. C−16
Side Cutter
Medium Wire
Ties (x2)
V3 Harness
Fog Light Wire
Fig. D−1
Status Monitor
4P (Black)
Status Monitor
Medium Wire Tie
Side Cutter
