N C
M Y
INSTALLATION INSTRUCTIONS
ELECTRICAL CONNECTION
x Electrical connections must be made in
accordance with local regulations.
x The electrical connection must be made only
by means of a Shuko socket with earth
connection, installed in accordance with
established legislation.
x Voltage, power consumption and earthing
information is shown on the service sticker
inside the door.
x The mains connection line must be replaced
by a licensed electrician only.
x The appliance complies with European safety
standards, EC directive 93/68 and EN
directive 60555
FOR GREAT BRITAIN ONLY
WARNING - THIS APPLIANCE
MUST BE EARTHED
Some appliances are supplied with moulded
plugs. To change a fuse on this type of plug
proceed as follows:
1. Remove fuse cover (A) and fuse (B)
2. Fit new fuse which should be a BS 1362
13A, A.S.T.A.
IMPORTANT:
x The fuse cover must be refitted after
changing a fuse
x In the event of a fuse cover being misplaced,
the plug must not be used until a correct
replacement is fitted.
x Please ensure that the replacement fuse
cover is of the same colour as the insert or
as the colour embossed in words on the
base of the plug.
If the moulded plug is not suitable for your
sockets it should be cut off and thrown away to
avoid any risk of electric shock if it were used in
a 13 A socket elsewhere.
A suitable alternative plug should then be fitted
to the cable.
Connection to a
typical 13 amp plug
HOW TO CONNECT A PLUG
The wires in this mains lead are colour-coded as
follows:
BLUE - NEUTRAL (N)
BROWN - LIVE (L)
GREEN AND YELLOW-EARTH (E)
1. The GREEN AND YELLOW wire must be
connected to the terminal in the plug which
is marked with the letter “E” or by the Earth
symbol
, or coloured green or green and
yellow.
2. TheBLUEwiremustbeconnectedtothe
terminal which is marked with the letter N or
coloured black.
3. The BROWN wire must be connected to the
terminal which is marked with the letter L or
coloured red.
FOR THE REPUBLIC OF IRELAND
ONLY
The information given in respect of Great Britain
will frequently apply, but a third type of plug
and socket is also used, the 2-pin, side earth
type. In this case the GREEN AND YELLOW wire
must be connected to the EARTH contact and
the other two wires to the terminals of the two
pins, irrespective of colour.
16
