Administration Settings
Logging
Cisco SPA100 Series Phone Adapters Administration Guide 122
5
Log Setting
If logging is enabled on the Administration > Log > Log Module page, the ATA can
periodically send the log file to a server or to an email address. Use the Log
Setting page to enter the information for your syslog server and email account.
NOTE For information about enabling and configuring logging, see Log Module,
page 124.
To open this page: Click Administration in the menu bar, and then click Log > Log
Setting in the navigation tree.
Enter the settings as described below. After making changes, click Submit to save
your settings, or click Cancel to abandon any unsaved entries.
Local
Syslog Server
E-Mail
When logging is enabled, you can send logs to an email address by using SMTP.
NOTE Service providers’ requirements vary. Be aware that some providers do not allow
SMTP email from a free account. Other providers may require a user to log on to a
new mailbox before sending emails. For accurate information, read the support
documentation from your provider. In your provider's support or help system,
search for information about SMTP server settings.
Field Description
Log Size Enter the maximum size of the log file in kilobytes. Valid
values are from 128 to 1024.
Field Description
IP Address Enter the IP address of the syslog server where the
messages will be sent.
Port Enter the port to use on the server. Valid values are from
1 to 65535.
