22
Factory Presets
The unit is supplied with the following preset programme which will be active after the
unit has been reset.
NB: 2nd ON and 2nd Off are set to the same time. These two times are ignored by the
programme and therefore the heating will just come on once in the morning and once in
the evening. If you want the heating to come on in the middle of the day set the 2nd on
and 2nd off to the times you require.
Accepting the preset times
If you are happy to use the setting above, you don’t need to do anything else.
To accept the presets press the programme button until the colon in the display begins to
flash.
Your unit is now in Run more
Programming event times in 24 hour mode
You can programme your timeswitch to come on and go off up to 3 times a day, to suit
your requirements.
Press programme until 1 shows along the top of the
display
Use the + and - buttons to set the time you want
your system to first come on in the morning
Press programme again to move to the next step
Use the + and - buttons to set the time you want your system to first go off
31
Press the On/off button to switch the appliance on. On initial start up full power is reached
after approximately 1-2 seconds
To rewind the power cable, press the rewind button with foot, and guide the cable with
hand to ensure that it does not whip causing damage
Rotate suction control knob clockwise to increase suction and anticlockwise to reduce
suction
Maintenance
Removing the contents of the dustbin
Always operate the cleaner with the dustbin installed. The dustbin must be emptied when
visibly full.
Remove the dustbin by pushing the button at the end of the carrying handle
Remove the dustbin filter from the dustbin
Remove the dust from the dustbin
Insert the dustbin filter back into the filter
Insert the dustbin back into the cleaner by pushing it until it clicks
If suction appears to be reduced when cleaning, please check filters as this is an indication
that they require cleaning. Filters should be changed at least twice a year.
Cleaning the dustbin filter
Remove the dustbin by pushing the button at the end of the carrying handle
If filter is lightly soiled, remove the dirt by tapping the filter into a bin, if heavily soiled,
tap the filter and then rinse under tap water
Let the filter dry. Avoid direct sunlight and extreme drying circumstances e.g. hair dryer
Insert the dustbin filter back into the dustbin
Insert the dustbin filter back into the cleaner by pushing until it clicks
Dustbin filter reference number ANC 407 136 316/4
Cleaning the motor filter
Remove the dustbin by pushing the button at the end of the carrying handle
If filter is lightly soiled, remove the dirt by tapping the filter into a bin, tap the filter and
then rinse under tap water
Let the filter dry. Avoid direct sunlight and extreme drying circumstances e.g. hair dryer
Put the filter back into its place
Close the filter cover
Recommended filters
Menaluz Motor Filer D24
Menalux Exhaust filter D09
