34
Start – after you have selected the desired programme and options, press this button to
start the washing machine. The light above the button will stop flashing and remain
lit.
Pause – when you press this button again, the programme in progress is interrupted.
The light above the button will start flashing. To restart the programme, press the
button again.
When you pause the cycle, the door locked light goes out, and it is possible to open
the door, provided
• The washing machine is not in the heating phase beyond 40 degrees C
• The level of water is not high
• The drum is not turning
8. Skip/reset button: The button performs two functions
• Clears the memory
• Selects special programmes
At the end of every programme the reset button must be pressed once or
repeatedly to clear the programme memory. All the programme phase indi-
cator lights must be off.
If the previous programme is not cleared, an audible signal will sound, when
you switch the machine on.
A normal wash cycle consists of the following phases, wash-rinses-spin and
is confirmed by the illumination of the cor
responding LED’s
19
Setting the correct time –
The current time of day is shown on the digital time display.
To change the time, press the + or – buttons until the correct time is displayed. Each press
of the button will adjust the time by 1 minute. Holding the button down will adjust the
time quickly.
Setting the on and off times-
The red tappets set the on times
The blue tappets set the off times
