5
INSTALLATION
GROUNDING INSTRUCTIONS
This appliance must be grounded. In the event
of malfunction or breakdown, grounding will
reduce the risk of electric shock by providing a
path of least resistance for electric current. This
appliance is equipped with a cord having an
equipment-grounding conductor and a
grounding plug. The plug must be plugged into
an appropriate outlet that is properly installed
and grounded in accordance with all local codes
and ordinances.
WARNING! Improper connection of the
equipment-grounding conductor can result
in a risk of electric shock. Check with a
qualified electrician or serviceman if you are
in doubt as to whether the appliance is
properly grounded.
Do not modify the plug provided with the
appliance. If it will not fit the outlet, have a
proper outlet installed by a qualified electrician.
DRAIN CONNECTIONDRAIN CONNECTION
DRAIN CONNECTIONDRAIN CONNECTION
DRAIN CONNECTION
The machine is supplied with the outlet hose already
attached. The hose should be extended over a suitable
sink edge or drain pipe at a minimum height of 24” to
a maximum height of 60” (610 mm to 1524 mm)
above the floor. (The lower height is preferable.)
Make sure that the hose is not kinked.
Drain hose: 3/4” (18.9 mm) ID
5.5 feet (1.7 m) long
Should you require an extension for the drain line,
the coupling must not be less than 1/2” ID. The
stand pipe for the drain should be 1-1/2” or larger
to prevent a vacuum from occurring.
ELECTRICAL INSTELECTRICAL INST
ELECTRICAL INSTELECTRICAL INST
ELECTRICAL INST
ALLAALLA
ALLAALLA
ALLA
TIONTION
TIONTION
TION
The electrical installation must be carried out by a
qualified electrician. The machine is delivered ready-
fitted with a 220V, 20A plug and is intended for
connection to an ASKO Dryer, which is equipped
with a matching receptacle. The plug supplied with
the washer can only be used with an ASKO Dryer.
If the washer is used separately or with another dryer,
it must be on a separate 220 V, 60 Hz single-phase
circuit.
If the machine is to be used in a wet area, the supply
must be protected by a residual current device.
As supplied: 208–230 V, 60 Hz
220V, 20A cord
2000 W heating element
