3
SHIPPING SUPPORTSSHIPPING SUPPORTS
SHIPPING SUPPORTSSHIPPING SUPPORTS
SHIPPING SUPPORTS
The machine is transported with three shipping
supports, as illustrated to the right. These supports
hold the tub in place during shipment. When you
unpack the machine, you must remove these
supports before you run the washer.
WARNINGWARNING
WARNINGWARNING
WARNING
Failure to remove the shipping supports before
you run the washer could damage the unit.
INSTALLATION
Read these instructions carefully and completely
before you install the machine. The installation
should be carried out by a qualified person who is
familiar with all local codes and ordinances for
electrical and plumbing connections.
NOTE:NOTE:
NOTE:NOTE:
NOTE:
Cosmetic damage must be reported to your dealer
within five days from the date of purchase. After
unpacking the washer, thoroughly check the unit
for cosmetic damage.
SPECIFICASPECIFICA
SPECIFICASPECIFICA
SPECIFICA
TIONSTIONS
TIONSTIONS
TIONS
Height 33-1/2”–34-1/2 (850–876 mm)
Width 23-7/16” (595 mm)
Depth W640/W660: 23-7/16" (595 mm)
W600/W620: 24-7/16” (620 mm)
With door open:
W640/W660: 36-3/8" (923 mm)
W600/W620: 42-3/8” (1075 mm)
Weight 167 lbs. (73 kg)
Rated load See data plate
Supply voltage Single-phase 208–240 V, 60 Hz
Heating element 2000 W
Fuses (2) 15 A in line
Drum and Barrel Stainless steel
Outer casing Stove-enamelled hot-dipped
galvanized steel
Mounting Four adjustable rubber-covered
feet
Inlet supply hose 5 ft. (1.5 m) PEX tubing with
brass ferrules
Supply pressure 15–142 PSI
Outlet hose 5.5 ft. (1.7 m) polypropylene hose,
3/4” ID
Power cord supplied 220V, 20A
You must remove the
shipping supports
before you install the
washer.
WARNINGWARNING
WARNINGWARNING
WARNING
Be careful of sharp edges.
To remove the shipping supports, follow the
instructions below:
1. Unscrew the 5/8” (13
mm) bolts holding
the supports in place
and remove the bolts.
2. Push the rubber spacer
up then pull it out of
the slot.
3. Rotate the spacer so that the
extruded end points toward
the machine. Insert it into the
slot and push down to lock it
into position.
4. Repeat procedures 1, 2, and 3 for the two
remaining shipping supports.
REMOVING THE SHIPPING SUPPORTSREMOVING THE SHIPPING SUPPORTS
REMOVING THE SHIPPING SUPPORTSREMOVING THE SHIPPING SUPPORTS
REMOVING THE SHIPPING SUPPORTS
Before the machine can be used, the three shipping
supports must be removed. Each support consists
of a bolt, a screw, a washer and a shipping sleeve.
The sleeves are used after the supports have been
removed, to plug the holes in the transport beam.
IMPORTIMPORT
IMPORTIMPORT
IMPORT
ANTANT
ANTANT
ANT
Keep the screws and washers in a safe place in
case the machine has to be transported again later
on.
