Levelling
Carefully level by screwing the adjustable
feet in or out. Never place cardboard, wood
or similar materials under the machine to
compensate for any unevenness in the
floor.
Water inlet
Attention!
• An inlet hose is supplied and can be found inside the machine drum.
• Do not use the hose from your previous machine to connect to
the water supply.
• This appliance must be connected to a cold water supply.
1. Open the porthole and extract the inlet hose.
2. Connect the hose with the angled connection to the machine.
Important!
Do not place the inlet hose downwards.
Angle the hose to the left or right
depending on the position of your water
tap.
3. Set the hose correctly by loosening the
ring nut. After positioning the inlet hose, be
sure to tighten the ring nut again to prevent
leaks.
4. Connect the hose to a tap with a 3/4” thread.
Always use the hose supplied with the appliance.
Installation should comply with local water
authority and building regulations’ require-
ments. A minimum water pressure of 0.05
MPa (0.5 bar) is required for safe operation
of the appliance.
If you cannot make the cold water connec-
tion direct from the rising mains, you may
be able to operate the appliance from your
cold water storage system. There should be
a minimum distance of 5.02m (16.5 ft) between theappliance’s inlet and
the bottom of the water storage tank.
82
Installation
HEC0006
P1088
132974420_gb.qxd 01/02/2007 14.38 Pagina 82
