7
Check that all ports were
n
installed. If there is an extra port,
go bock through the steps to see which
step was skipped.
8
n
Check that you hove all your tools.
9
Take a few minutes to read the
n
Use and Core Guide so you con
get the best use from your new
portable dishwasher. Then move the
dishwasher to the location where it will
be used.
10
Turn on the hot water faucet
n
until water is hot. Turn the
faucet off, Pull the inlet/drain hose from
the storage compartment. Attach the
hose connector to the faucet by pulling
down on the locking collar while
pushing the connector over the faucet
adapter. It will snap into place. Release
the locking collar.
ii
Untape the power supply
n
cord and plug it into the
grounded outlet. Open the dishwasher
door and spin the spray arm to check
for movement. Close the door.
12
Turn hot water faucet to
H
fully open position. Start
dishwasher.
13
Check for leaks around the
n
door and mounting gasket,
and at the hose connections.
Product/Property Damage
Turn water faucet off and press
bleeder button to release water
pressure before removing the drain
hose from faucet.
Failure to do so before removing
drain hose may result in product or
property damage.
14
When the cycle is complete,
n
unplug power supply cord and
push cord into storage compartment.
Turn the water faucet off. Press the
bleeder button on the connector to
release the water pressure. With one
hand, move the locking collar
downward while using the other hand
to pull down on the connector. Turn the
connector upside down and empty any
water remaining inside the connector.
Check for complete drain (no water
should be visible).
15
Push hoses into storage
H compartment.
Congratulations!
You have just finished installing
your new dishwasher. Keep
Installation Instructions available
for easy reference.
Converting to
built-h
Your portable dishwasher con be
converted to a built-in (undercounter)
model by using conversion kit, Part No.
43 17856. The kit is available from your
dealer or authorized parts distributor.
Installation Instructions ore included
with the kit.
To than
e door
panel co
1
or
(For models so equipped.)
Personal Injury Hazard
Wear gloves and handle panels
carefully.
Cut metal edges may cause
personal injury or damage to other
materials.
Insert finger under one end of
retainer and pull towards you in
a peeling action. Set retainer aside.
2
Lift
n
door
panel(s
outer edges.
Use one hand
to bow bottom
of panel(s).
Remove
panel(s). Do Not
remove spacer.
3
Insert one
n
side of
door panel(s),
with desired color
facing out, into
one side of door
frame.
4
Bow door
H panel(s)
and insert other
side of door
panel(s) into
door frame.
control console
5
Push in
n
on door
panel(s) near the top
and slide panel(s) and
spacer up inside
bottom of control
console, allowing
panel(s) to rest on
channel at bottom
of door.
Snap into
Push in
channel.
along
6
Snap one end of retainer into
n
channel as shown. Push inward
while sliding thumb along full length of
retainer.
Panel C
