Before you start...
Check the area where you will be using
the portable dishwasher. Proper
installation for operation is your
responsibility. Make sure you have
everything necessary to insure correct
operation.
Water heater: Should be set to deliver
12O’F water to dishwasher for best
results.
Electrical Shock Hazard
It is the customer’s responsibility:
l
To contact a qualified electrical
installer.
l
To assure that the electrical
installation is adequate and in
conformance with National
Electrical Code ANSI/NFPA 70 -
latest edition,* and all local codes
and ordinances.
Failure to do so could result in fire,
electrical shock or other personal
injury.
Grounded electrical outlet
is required.
See “Electrical
Hot water faucet or hot and cold single-
spout water faucet: Should be
accessible within 30 inches of the back
of the dishwasher and should provide
15-120 PSI water pressure.
Important: Observe all governing
codes and ordinances.
Copies of the standards listed may be
obtained from:
*National Fire Protection Association
Batterymarch Park
Quincy, Massachusetts 02269
Remove parts and
from the
and latch dishwasher door.
Drain: To drain your
dishwasher, you
need a sink or a
laundry tub having
a minimum carrv-
away capacity of 7
gallons per minute.
The top of the sink or
laundry tub cannot
be lower than 27
inches or higher
than 48 inches from
Lust
be:? Of the
support’the appliance weight of 180
pounds.
Tools needed for
Electrical
installation:
requirements
Parts supplied for
installatgon:
faucet
adapter kit
4 casters
Part No.
3374592
Electrical Shock Hazard
l
Electrical ground is required on this
appliance.
l
Do Not ground to gas pipe.
l
Do Not modify the power supply
cord. If the plug does not fit the
outlet, have a proper outlet
installed by
a
qualified electrician.
l
Do Not have a fuse in the neutral
or grounding circuit. A fuse in the
neutral or grounding circuit could
result in electrical shock.
l
Do Not use an extension cord with
this appliance.
l
Check with a qualified electrician
as to whether the appliance is
properly grounded.
Failure to follow these instructions
could result in a serious injury or
death.
If codes permit and a separate
grounding wire is used, it is
recommended that a qualified
electrician determine that the
grounding path is adequate.
A 120-volt, 60-Hz, AC-only, 15 or 20-
ampere, fused, electrical supply is
required. Time-delay fuse or circuit
breaker is recommended. it is
recommended that a separate circuit
serving only this appliance be
provided.
Recommended
grounding method
For your personal safety, this appliance
must be grounded. This appliance is
equipped with a power supply cord
having a 3-prong, grounding plug. To
minimize the risk of electrical shock, it
must be plugged into a mating 3-prong,
grounding-type wall receptacle,
grounded in accordance with the
National Electrical Code ANSVNFPA 70
- latest edition*, and all local codes
and ordinances. If a mating wall
receptacle is not available, it is the
personal responsibility and obligation of
the customer to have a properly
grounded, 3-prong wall receptacle
installed by a qualified electrician.
(See Figure 1.)
3-prong. grounding-
type wall receptacle
Figure 1
1 literature package
Panel A
