7
905077 REV B 7/23/14, 1970-78 CAMARO WITH A/C EVAP KIT PG 7 OF 28
NOTE: Removal of dashboard is required to install the evaporator. Vintage Air recommends that you
utilize the factory service manual when you disassemble and reassemble the dashboard.
Glove Box
Instrument
Panel
Control
Panel
Driver Side
Louver
Kick Panel
Kick Panel
Fresh Air Cover
Glove Box
Door
A/C and Heater Assembly
& Related Ducting
Figure 5
Figure 6
1. Glove box door (See Figure 6, below).
2. Glove box (discard, retain screws) (See Figure 5, below).
3. A/C, heater/evaporator assembly and all related ducting (discard), retain screws (See Figure 6, below).
4. A/C heat outlets (retain). Instrument panel must be removed to get to left outlet and control panel
(See Figure 6, below).
5. Control panel assembly (retain control panel) (See Figure 6, below). Refer to control panel conversion kit
instructions for installation of controls.
6. Remove passenger side kick panel fresh air cover (discard) and kick panel (retain). Remove cable (discard)
from panel (See Figure 6, below).
7. Remove OEM defrost duct assembly.
Passenger Compartment
Remove the Following:
