Dil ID: 6
Dil Adı: turkish
Dil Kodu: tr2tayfun Whirlpool Markası'nın Ürünleri
Dünyanın En Büyük
Elektronik Bilgi Kütüphanesi



85
WHEN TO REMOVE THE FILTER
Check and clean the filter at least 2 or 3 times
a year.
When the appliance does not drain or spin
properly.
When the pump is blocked by an object
(buttons, coins, safety pins).
IMPORTANT:
Before draining, make sure that
the water has cooled.
REMOVING THE FILTER
1.
Switch off the appliance (set the programme
selector to 0).
Open the filter cover using the coloured insert
from the detergent drawer.
3.
Place a tub or container beneath it.
Slowly turn the filter anticlockwise until its
handle is vertical without unscrewing it
completely.
5.
Wait until all the water has drained.
Now unscrew the filter completely and
remove it.
7.
Remove any foreign material from the filter.
Check that the pump rotor moves freely.
9.
Insert the filter and screw it in clockwise until
it locks (until the grip is horizontal).
10.
Close the cover.
11.
Pour 1/2 litre of water into the detergent
drawer to reactivate the Eco system.
12.
Select the desired programme and hold
down the Start button for about 1 second.
WHEN TO DRAIN RESIDUAL WATER
When transporting (moving) the machine.
If there is danger of freezing in the installation
room. In this case the machine should be
drained after every wash.
DRAINING RESIDUAL WATER
The residual water drain hose (if provided) is
located in the machine plinth. If the machine is
not provided with a drain hose in the plinth,
remove the filter to drain residual water (see
Removing The Filter).
Lift the cover upwards with light pressure.
Pull out the hose by about 15 cm.
Pull off its endcap.
Let the water drain into a flat container until
the flow stops.
Close the drain hose and replace it.
4.
On next use, pour about 1 litre of water into
the detergent drawer to reactivate the Eco
system.
REMOVING THE FILTER / DRAINING RESIDUAL WATER
2.
4.
6.
8.
1.
2.
3.
1.
2.
3.
8.
2.
4.
6.