84
Indicates the programme selected and the current
step in the sequence.
Green zone:
Main wash.
Black stripes:
Rinse.
Solid black zone:
Final spin.
“Stop”:
Programme end.
DOOR LOCK
The door locks automatically after the programme
start until the end of the programme.
IMPORTANT:
During the first 15 minutes of the
Cotton and Synthetic programmes (without
Prewash) you can open the door to add items to
the wash. This is not possible when the special
option “Quick Wash” / “Rapid” is selected.
If the programme selector is set to “0” or the
electrical supply is interrupted, the door lock will
open after approximately 2 minutes.
PROGRAMME END
1.
The programme sequence indicator is at
“Stop”. Only attempt to open the door after
this.
2.
Set the programme selector to “0”.
The indicator light turns off.
3.
Cancel the special options by pressing the
appropriate buttons.
4.
Open the door and unload the machine.
5.
Turn off the tap(s).
Note:
Do not fully close the door but leave it ajar
to allow the drum to dry out.
PROGRAMME RESELECTION
a. CONTINUING WITH A NEW PROGRAMME
OR TEMPERATURE SETTING
1.
Select the new programme or
temperature.
2.
Hold down the Start button for about 1
second.
The new programme will continue fwith
the same programme step at which the
previous programme was interrupted.
b. CANCELLING THE CURRENT
PROGRAMME AND RESTARTING WITH A
DIFFERENT ONE
There's no need to add more detergent when
you start the new programme, since almost
no water is drained out when a programme is
cancelled.
1.
Hold down the Start button for about 5
seconds or until the programme control
audibly restarts.
2.
Wait until the programme sequence
indicator reaches “Stop”.
3.
Set the programme selector to “0”.
4.
Set the programme selector to the new
programme, selecting the new
temperature and any special functions
required.
5.
Hold down the Start button for about 1
second.
TO INTERRUPT / PAUSE A
PROGRAMME
To interrupt a programme that is already running
and then restart it later:
1.
Set the programme selector to “0”.
2.
After the desired break, reselect the
programme.
3.
Hold down the Start button for about 1
second.
The programme will continue from where it
was interrupted.
TO STOP A PROGRAMME BEFORE THE
END / DRAINING
To stop the programme before it has finished and
drain the water:
1.
Set the programme selector to “B” (Gentle
spin).
2.
Set the Spin Speed selector to (No spin).
3.
Hold down the Start button for about 1
second.
The machine drains.
Only open the door when the programme
sequence indicator has reached “Stop”.
PROGRAMME SEQUENCE INDICATOR
DOOR LOCK / PROGRAMME END
PROGRAMME RESELECTION /
INTERRUPTING THE PROGRAMME
