
SCION xD/xB 2008- LEATHER STEERING WHEEL
Procedure
Page 3 of 12 pages
Issue: B 04/18/07
DIO only
3. Remove the Steering Pad
(a) Using a T30 “torx” socket, loosen the 2
screws until the groove along each screw
circumference catches on the screw case.
(Fig. 3-1)
(b) Pull the steering pad assembly straight off.
Support the steering pad with one hand.
Notice: When removing the steering pad,
do not pull the airbag wire harness.
(c) Unlock the connectors for airbag, which are
on the back of the steering pad assembly,
with a small flathead screwdriver and
remove. (Fig. 3-2)
(d) Remove the horn wire/connector from the
steering pad assembly by pressing the
release tab on the terminal.
(e) Set aside the steering pad assembly away
from direct sunlight/heat/moisture, with the
emblem always facing up.
(f) Remove connector for spiral cable. (Fig. 3-2)
(g) Remove cruise control 2P connector from
spiral cable. (Fig. 3-3)
Note: Step 3. (g) does not apply if the
vehicle does not have cruise control.
Fig. 3-2
Small Flathead Screwdrive
Unlock to loosen
the connector
2P Connecto
2P Connectors
for Air Bag
Harness for Horn
Connector for Spiral Cable
Fig 3-1
Remove
2P
Connector
from Spiral
Cable
Fig. 3-3