3.14 F 10 Water intake fault cold water
Symptom
The message in the operating mode: Water intake fault.
The LED “check water intake” flashes rapidly.
The program is stopped, the water intake valve is closed, and the drain pump is
switched on for 120 seconds.
Water intake control refer to 040 2.4 Water intake monitoring – water control
system (WCS).
Cause
Only until the first commissioning: The spin lock is activated.
Remedy
A Run a short wash program up to water intake. As the first water intake is
registered, the spin lock is released.
x
Note
Spin lock, refer to 060 2.1 Spin lock.
Cause
The appliance has a leak, the water control system (WCS) has stopped the water
intake.
Remedy
A Shut off the water faucet.
A Locate the leak and fix it.
Cause
The water faucet is closed.
Remedy
A Open the faucet.
Cause
Water intake filters are gunked up.
Descriptive Technical Documentation
070-18 DTD no. 11-4800
This information should not be duplicated or passed on without Miele approval. All rights reserved. 22.12.2006, US_am
