78 BSGX4e Business Gateway User Guide
NN47928-102 Release 01.01
For more information about the authority granted to user accounts, see “User
Accounts, Groups and Rights” (page 61).
The Command Line Interpreter executes a command as soon as it receives it.
If the entire command is entered on one line, the command is executed
immediately after the <enter> key is typed.
If the command is entered in interactive mode (see “Interactive Mode” (page
82)), the command is executed as soon as its entry is complete (after entry of
exit or <cntrl-z>).
NOTE: Although config commands change the current configuration
immediately, the changes can be lost if the unit restarts. To save the
changes to permanent memory, enter a save command.
Logging Off
A session begins with a logon using a valid user account and password. The session
ends when:
An exit command is entered, or
The session inactivity timer expires. By default, a session expires after five
minutes of inactivity (see “Customizing the Command Session” (page 78)).
Exit Command
The exit command ends the session without saving configuration changes to
nonvolatile memory. Assuming the unit does not restart, the configuration remains
the same at the next logon, including the changes that were not saved by the last
session.
In the following example, asterisks in a command prompt indicate that changes have
not been saved. The exit command ends the current session; the logon starts a new
session. The command prompt in the new session still has asterisks, showing that
configuration changes have not been saved:
*BSGX4e*> exit
Logging off
User logout. Goodbye!
User: nnadmin
Password:
*BSGX4e*>
Customizing the Command Session
You can change any of the following terminal settings:
