BSGX4e Business Gateway User Guide 49
Release 01.01 NN47928-102
Initial Setup
SNTP:
Enabled on
Server 1 ntpserver.wan.com
Server 2 0.0.0.0
Server 3 0.0.0.0
Server 4 0.0.0.0
Gmt Offset +01:00
Sync Interval 7 days
Last Sync FRI FEB 17 15:53:25 2006
Next Sync FRI FEB 24 15:53:25 2006
Changing SNTP Servers
To change the SNTP servers, disable the SNTP client first. The following command
sequence clears the second SNTP server:
> config system sntp no enabled
*> config system sntp no server2
*> config system sntp enabled
*> save
Watchdog Reset Timer
The watchdog reset timer allows the BSGX4e unit to automatically restart after a
software failure. This timer is required because such a failure could possibly
“freeze” the unit so that no traffic can be routed through it. The automatic reset
allows the unit to recover from that state and restores it to normal operation.
NOTE: It is recommended that the initial watchdog configuration remain
unchanged. The initial configuration enables the reset timer and sets its
value to seven seconds.
Watchdog Timer Command
To configure the watchdog timer, enter the following command:
> config system watchdog
Table 12 describes the parameters for config system watchdog.
Table 12. System Watchdog Configuration Parameters
Parameter Description
enabled Enables the watchdog timer (Boolean). Initially, the timer is enabled.
refresh Refresh interval for the timer (in seconds). The default is seven
seconds.
