3. Press button 4 again to start the programme.
The selected delay can be changed only after selecting the washing programme again.
The door will be locked throughout the delay time (door locked light lit).
The Delay Start can not be selected with DRAIN or SPIN programme.
Start the programme by pressing button 4
To start the selected programme, press this button; the corresponding pilot light stops
flashing and remains lit.
The indicator lamp of a current washing phase in the programme progress display is lit and
the door is locked.
Altering an option or a running programme
It is possible to change any option before the programme carries it out.
Before you make any change, you must pause the washing machine by pressing the button
4.
The programme can be changed as long as the button 4 has not been pressed. Changing a
running programme is possible only by resetting it. Turn the programme selector dial to
"AUS/ARRÊT" and then to the new programme position. Start the new programme by press-
ing the button 4 again.
Interrupting a programme
Press the button 7 to interrupt a programme which is running, the corresponding light
starts blinking. Press the button again to restart the programme.
Cancelling a programme
Turn the selector dial to "AUS/ARRÊT" position to cancel a programme which is running.
Now you can select a new programme.
Opening the door after the programme has started
First set the machine to pause by pressing the button 4.
After some minutes, the door can be opened, when the following conditions are observed:
• The water temperature is below 55 °C.
• The water level is below the bottom edge of the door.
• The machine doesn’t spin.
If you cannot open the door but it is absolutely necessary to open it you have to switch the
machine off by turning the selector dial to "AUS/ARRÊT " position. After few minutes the
door can be opened
(Pay attention to the water level and temperature!).
After this procedure, it will be necessary to set the programme and the options again and
then press the button 4.
At the end of the programme
The machine stops automatically.
The pilot light "ENDE/FIN" illuminates to indicate that the programme has finished. After a
few minutes the door can be opened and the laundry can be removed.
If at the end of a programme there is water in the tub (when "Rinse hold" option has been
selected), to empty out the water follow the following instructions:
Daily use
13
