Operating Instructions
26
3
The washing machine switches itself into the stand-by mode if no but-
ton is pressed or the program selector is not turned within approx. 3
minutes after the end of the program. Only END is illuminated from be-
hind. All other displays on the control panel are switched off in order to
save energy. Pressing any arbitrary button cancels the stand-by mode.
• If the program EASY IRON was selected, an anti-crease phase of ap-
prox. 30 minutes follows the program end. The multidisplay shows a
remaining time and the display END lights up. During the anti-crease
phase, you can open the door at any time and remove the washing.
• If the spin speed 0 (Rinse Hold) was selected, START/PAUSE flashes.
0 1. After a rinse hold, it is first necessary to pump off the water:
– Either press the button START/PAUSE (water is pumped off and the
washing is spun according to the completed program; With the but-
ton SPIN SPEED, it is also possible to still change the spin speed dur-
ing spinning), or
– Turn the program selector to PUMP OUT and press the button
START/PAUSE (the water is pumped off without spinning), or
– Turn the program selector to SPIN or GENTLE SPIN and press the but-
ton START/PAUSE (the water is pumped out and the washing is spun
or gently spun).
After the end of this program step END is illuminated from the rear.
2. Open the filling door.
As soon as DOOR/LIGHT is illuminated green from the rear the door can
be opened (not when Program Saving is activated, also see "Program
Saving“).
3. Remove the washing.
4. Turn the program selector to OFF.
5. After washing, pull out the washing detergent drawer slightly so that it
can dry out. Only lean the door against the washing machine so that
the latter can air out.
3
If OVER DOSING is illuminated from the rear, too much
detergent was used in the washing program which has
just ended. During the next wash, pay attention to the detergent ma-
nufacturer's dosing information and to the load quantity!
Caution! If the washing machine is not used for a long time:
Close the water tap and disconnect the washing machine from the
electricity mains. (Anti-flood system Aqua Control with Aqua Alarm
does not function if the power supply is interrupted.)
