Operating Instructions
24
Start the washing program
0 1. Check that the water valve is open.
2. Start the washing program: Press the button START/PAUSE.
The washing program is started or it starts after the set
time expires.
3
If DOOR/LIGHT flashes red when the button START/PAUSE is pressed,
the door is not properly closed. Press the door firmly closed and press
the button START/PAUSE again.
If the time preselection is set:
The set time delay runs. The remaining time until the program start is
shown in the Multidisplay (always in full hours). During this time you
can load washing or change / abort the time preselection.
• Load washing: Press the button START/PAUSE. The door can be
opened. Then close the door and again press the button START/
PAUSE.
• Change or abort time preselection: Press the button DELAY TIMER as
often as necessary until the required time is displayed; When the pro-
gram duration is displayed (shown in minutes, e. g. 125), the washing
program starts without a delay.
3
While the time delay is running, the washing machine switches to
Stand-by mode. Only WASH TIME is illuminated from behind. The
multidisplay shows the remaining time until the program start. All
other displays on the control panel are switched off in order to save en-
ergy. Pressing any arbitrary button cancels the stand-by mode.
Completion of the Washing Program
Program sequence display
Before the start, the program steps to be run are shown
by the program sequence display. The current program
step is displayed during the washing program.
Multi-display
The expected remaining duration (in minutes) is
shown in the multidisplay until the end of the
program.
