Where you mount the speaker will determine how you run the wire. Since this is only a
temporary install while I wait for Reed’s onstar interface box, I decided just to leave the
speaker on the rear center hump. As it turns out, this is a very good place. It is out of the
way, exposed (so the sound quality is good, as opposed to being tucked underneath the
dash) and far enough from the microphone so your caller does not get feedback.
Run the wire under the sound blanket and up to where you pulled the mic and pad cables
from.
Route them all around the black rubber piece just as you did the blue rap wire.
CONGRATULATIONS! You are done running wires!!!
