10
->1
Dial:
Terminating an enquiry call/second call
Terminate the enquiry call/second call by pressing the
END key.
Press the Foxkey under “->1” to return to the first call.
You can also terminate an enquiry call by pressing the programmed auto-dial key (see
“Programming auto-dial keys”).
After pressing the END key you can press the programmed auto-dial key to return to
the first call.
Brokering (switching between calls)
You have initiated an enquiry call and wish to alternate between the two calls.
Press the Foxkey under “->1” to return to the first call, press under “->2” to return to the enquiry
call.
You can also switch between calls using the programmed auto-dial keys (see
“Programming auto-dial keys”).
Call transfer
Contact your telecoms operator for information on the introduction date for this service.
If you have initiated an enquiry call and wish to connect the two calls (call transfer):
Press the relevant programmed auto-dial key (see “Programming auto-dial keys”) to connect the
two calls. Replace the handset.
Even after transfer, the call is still charged to the originating party.
If the telephone is connected to a PBX, you can transfer a call simply by replacing the
handset (see “PBX connection”).
If the telephone is connected to a PBX, please refer to the relevant section in your PBX
operating manual.
Initiating a three-way conference call
Contact your telecoms operator for information on the introduction date for this service.
You have initiated an enquiry call and wish to speak to both call partners simultaneously.
Press the auto-dial key which has been pre-programmed for this purpose (see section on
“Programming auto-dial keys”).
If the telephone is connected to a PBX, please refer to the relevant section in your PBX
operating manual.
Using the extended-feature functions
ETK30_2.PM6 19.03.97, 17:2810
