TD 92675EN
20 June 2012 / Ver. E
Configuration Manual
Ascom i62 VoWiFi Handset
16
5. Maintenance
5. Maintenance
5.1 Handset
In an existing VoWiFi system it is important to be able to replace handsets, install new
handsets and exchange faulty handsets. The recommended procedure is to use a template
with basic network settings for log in, created in the PDM, and then get the rest of the
settings that were created by the templates in Device Manager in IMS3.
Another important matter is to be able to upgrade system parameters and security settings
in the handsets. These upgrades are preferably done in the IMS3 if available.
If PDM and IMS3 are used, do one of the following:
• If you want to install new handset, see 4.1 Installation with Central Device Management
(IMS3) on page 9.
• If you want to create spare handsets to be used when broken handsets need to be
replace
d lat
er on, see 5.1.1 Configure Spare Handsets without a Number in Large
Sys
tems.
If only PDM is used, do one of
the following:
• If you want to install new handset, see 4.2 Installation without Central Device
Management (IMS3) on page 12.
• If you want to replace a broken handset, see 5.2.4 Replacement of Handset with PDM
Only on page 25.
5.1.1 Configure Spare Handsets without a Number in Large Systems
In large systems where IMS3 is used, it is recommended to confi
g
ure a couple of spare
handsets without a number in order to quickly replace a broken handset later on.
Create a Template
1 Open PDM.
2 Select the Temp
lates tab and click “New“. The New template window is opened.
3In the Device type and P
arameter version drop-down lists, select the matching device
type and parameter version for the spare handset to use, respectively.
4In the Name field,
enter a descriptive name of the template.
5Click “OK“.
6 Set the following network parameters:
• Network settings
1
(located under Network > Network A, B, C, or D)
• VoIP settings
2
(located under VoIP)
• Syslog settings
3
(if any) (located under Device > General)
• Unite settings
4
(if any) (located under Device > Unite)
7 Click “OK“ to save the template.
Apply Template to a Handset without a Number
1 Put the handset in the Desktop Programmer (DP1) cradle
1. All required system settings for the WLAN. For example SSID and Security mode.
2. For example VoIP protocol, Gatekeeper IP address or SIP proxy IP address used to access the PBX.
3. The parameter “Syslog“ must be enabled in order to set the “Syslog IP addre
ss“.
4. IP address and password (if any)
to the IMS3.
