TD 92675EN
20 June 2012 / Ver. E
Configuration Manual
Ascom i62 VoWiFi Handset
14
4. Installation of VoWiFi
4.4.1 Create a template
1 Open the PDM or the Device Manager in the IMS3.
2 Select the Templa
tes tab and open the menu “Template > New...“. The New Template
window is opened.
3 Select the device type and parameter versio
n that matches the software version
installed on the handset. Give the template a descriptive name.
The parameters that are not part of the template wi
ll be left unchanged on the handset. The
parameter version of an installed handset is visible under the Numbers tab or the Devices
tab.
4Click “OK“.
5 Select the check box of each parameter that yo
u want to be part of this template and
enter the proper value.
6 Click “OK“ to save the template.
4.4.2 Apply a Template to a Handset with a Number
1 Open the PDM or the Device Manager in the IMS3.
2In the Numbers tab, select the hand
set(s) you want to apply the template to.
NOTE: If several handsets shall be selected, they must be of the same
device type and have
the same parameter version.
3 Make a right-click and select “Run template...“.
Only templates with a parameters version matching the selected handsets will be shown.
Select the template you want to apply and click “OK“.
The template is applied. The number of parameters in the template will affect the time it
takes to apply the template to the selected handsets.
When looking at a handset under the Numbers tab, the column “Last run template“ will
show the name of the most recently applied template.
Tip: It is also possible to apply a template on several handsets of the same device type
simultaneously using the Baseline function, see Installation and Operation Manual, IMS3,
TD 92762EN. This function cannot be used to download certificates to the handsets.
4.4.3 Apply a Template to a Handset without a Number
NOTE: This feature is only applicable for the PDM
.
However, in the Device Manager in IMS3, it
is possible to apply a template to a handset without a number using the Baseline
function. The Baseline function or a template cannot be used to download certificates
to the handsets. See Installation and Operation Manual, IMS3, TD 92762EN.
It is possible to apply a template to a
handset
without a number in the PDM.
1 Put the handset in the Desktop Programmer (DP1) cradle
2In the Foun
d Device Wizard window, select the “Run template“ option.
3 Click “Next >“.
Only templates with a parameter version matching the sel
e
cted handset will be shown.
4 Select the template that shall be applied and click “OK“.
The template is applied. The number of parameters in the template will affect the time it
takes to ap
ply the template to the selected handset.
