TD 92675EN
20 June 2012 / Ver. E
Configuration Manual
Ascom i62 VoWiFi Handset
15
4. Installation of VoWiFi
4.4.4 Save Handset Configuration as a Template
It is possible to save all settings of a handset as tem
plate. Note that this does not include
contacts, certificates and other personal data. The template will only contain configuration
data.
This template can be used as a backup if you want to restore the configuration of the
handset at a later stage or as a template that can be applied to a number of handsets.
1 Open PDM or the Device Manager in the IMS3.
2In the Numbers tab, select the hand
set you want to save as a template.
3 Make a right-click and select “Use as a template...“. Enter a descriptive name for th
e
template.
4The Edit template window is opened. By default, all parameters are selected and are
save
d when clicking “OK“.
If one or more parameters should be excluded,
remove them by clearing the check
box next to the parameter.
Some parameters are user specific. If it is decided to a
pply this type of template to
several handsets, it is recommended to exclude the following parameters:
• User display text - A text string displayed in idle mode. The pa
rameter is located
directly under “Settings“.
• Phone lock PIN code - The security code used to unlock the keypad. The parameter
is
located under Settings > Locks.
• Endpoint ID - The identity/name of the user registered in the PBX. The paramete
r
is located under VoIP > General.
5Click “OK“.
4.4.5 Synchronizing a Handset with PDM
After installing and saving a handset, it will be synchronized each time it is connected to the
PDM. Th
e synchronization transfers parameter changes between the handset and the PDM
and vice versa as follows:
• If a parameter has been changed in the handset, it will be tr
ansferred to the PDM/IMS3.
• If a parameter has been changed in the PDM/IMS3 while t
he handset was disconnected,
it will be transferred to the handset.
If the same parameter has been changed in both the PDM
/IMS3 and the handset, the value
in PDM/IMS3 will be transferred to the handset.
4.4.6 Configure Handset without Saving It in PDM
It is possible to configure a handset without saving it in the PDM. An unsaved hand
set do
not have the symbol in the Saved column. The settings in the handset can be
synchronized and saved in the PDM later on. However, it is recommended to save the
handset in PDM if backup is needed. For example when a handset needs to be replaced.
1 Put the handset in the Desktop Programmer (DP1) cradle
2 Open PDM.
3In the Numbers tab, select the unsa
ved handset you want to configure.
4 Select Number > Edit parameters.
5The Edit parameter
s window is opene
d. Edit the parameters of the handset and click
“OK“.
6 Remove the handset from the Desktop Programmer (DP1) cradle. The handset is no
longer visible in the PDM and t
he settings are only saved in the handset.
