VDSL Hospitality 100+ Rooms Setup Guide
1/05/05 Page 8 of 23
Configuration
How to setup the VSG-1200
We’ll begin be setting up the VSG-1200 service gateway. This will act as the gateway for all users.
IP address setup
1. Please plug the console cable into the VSG-1200, and connect it to serial port on your PC.
2. Run a terminal tool (ex, HyperTerminal) and the settings are 9600 bps, 8 data bits, no parity
bits, 1 stop bit, and no flow control.
3. Log into the device; the default username/password is admin/1234.
4. Please enter menu 2, and insert the settings for your WAN IP address (the public address
provided by your ISP) and DNS Server information. If you don’t know what settings you use,
contact your ISP for support.
5. After setting these parameters, please continue press the “Enter” until the console shows
“S)ave and return R)eturn without saving M)odify:”. Please type “S” and press “Enter”. Then
the system will request to restart.
Connect the Ethernet cable to WAN or LAN
1. Use a crossover cable (typically a red-colored Ethernet cable) from the WAN port of the VSG-
1200, connected to directly to your computer’s Ethernet port. Alternately, you can connect
your PC using the 4 switch ports on the LAN using a standard Ethernet cable.
