
A
D
5
Put filter (A) to its ini-
tial position. Make
sure that it assembles
correctly under the
two guides (D).
6
Assemble filters (B)
and (C). Put them in-
to position in filter
(A). Turn the handle
clockwise until it
locks.
An incorrect position of the filters can
cause bad washing results and damage to
the appliance.
Cleaning the spray arms
Do not remove the spray arms.
If the holes in the spray arms are clogged, re-
move remaining parts of soil with a thin pointed
object.
External cleaning
Clean the appliance with a moist soft cloth.
Only use neutral detergents. Do not use abra-
sive products, abrasive cleaning pads or sol-
vents.
Troubleshooting
The appliance does not start or it stops during
operation.
Before you contact the Service, refer to the in-
formation that follows for a solution to the prob-
lem.
With some problems, different indicators
flash continuously or intermittently at the
same time to show an alarm code.
Alarm code Problem
• The start indicator flashes continuously.
• The end indicator flashes 1 time intermittently.
The appliance does not fill with water.
• The start indicator flashes continuously.
• The end indicator flashes 2 times intermittently.
The appliance does not drain the water.
• The start indicator flashes continuously.
• The end indicator flashes 3 times intermittently.
The anti-flood device is on.
Warning! Deactivate the appliance before
you do the checks. Turn the programme
knob until the programme marker is aligned
with the on/off indicator.
Problem Possible solution
You cannot activate the appliance. Make sure that the mains plug is connected to the mains
socket.
Make sure that there is not a damaged fuse in the fuse box.
The programme does not start. Make sure that the appliance door is closed.
Press the start button.
If the delay start is set, cancel the setting or wait for the end
of the countdown.
The appliance does not fill with water. Make sure that the water tap is open.
11
www.zanussi.com