
Using the detergent
Caution! Use only detergents for
dishwashers.
Do not use more than the correct quantity
of detergent. Refer to the instructions on
the detergent packaging.
1
2
3
4
5
If the programme has
a prewash phase, put
a small quantity of
detergent on the in-
ner part of the appli-
ance door.
Detergent tablets do not fully dissolve with
short programmes and detergent residues
can stay on the dishes.
We recommend that you use detergent tablets
with long programmes.
Using the combi detergent tablets
When you use tablets, that contain salt and
rinse aid, do not fill the salt container and the
rinse aid dispenser. The rinse aid indicator al-
ways comes on if the rinse aid dispenser is
empty.
1. Adjust the water softener to the lowest lev-
el.
2. Set the rinse aid dispenser to the lowest
position.
If you stop to use the combi detergent
tablets, before you start to use separately
detergent, rinse aid and dishwasher salt,
do these steps:
1. Set the water softener to the highest level.
2. Make sure that the salt container and the
rinse aid dispenser are full.
3. Start the shortest programme with a rinsing
phase, without detergent and without
dishes.
4. Adjust the water softener to the water hard-
ness in your area.
5. Adjust the released quantity of rinse aid.
Setting and starting a programme
Setting mode
The appliance must be in setting mode to
start a programme.
• Turn the programme knob until the pro-
gramme marker is aligned with a programme
on the control panel. If the on/off indicator
comes on, the appliance is in setting mode.
• Turn the programme knob until the pro-
gramme marker is aligned with a programme
on the control panel. If the on/off indicator
and the start indicator come on, the appli-
ance is not in setting mode.
To put the appliance in setting mode, press and
hold the start button until the start indicator
goes off .
Starting a programme without delay start
1. Open the water tap.
8
www.zanussi.com