Alternate methods:
Droin hose to woste tee.
Cut hose
connector
to fit.
screw- or
spring-type
clamp
’ J—r i
1 r o Entry must be
T (50.8 cm) above trap
minimum
clearance
to floor
If local plumbing codes permit,
dishwasher drain hose may be
connected directly to waste
tee. The waste tee connection
MUST be made ahead of the
trap and a minimum of 20
Inches (50.8 cm) above the
floor.
f 20"
(50.8 cm)
minimum
clearance to
floor
Do Not cut
hose
connector,
screw- or
spring-type
' clamp
Entry must be
above trap.
If local plumbing codes permit,
dishwasher drain hose may be
connected directly to disposer.
Most disposers have 7/8"
connectors or special
connectors are available at
plumbing supply houses.
Knock out disposer Inlet plug
from Inlet. If Inlet plug
falls Inside disposer,
you must remove
Inlet plug before
connecting drain
hose. If disposer Is
already Installed In
sink, you may need to
take out disposer to
remove Inlet plug.
Installation steps
With dishwasher in kitchen.
Awarning
Electrical Shock Hazard
Disconnect electrical power at the
fuse box or circuit breaker box
before installing dishwasher.
Make sure that the water supply
line, drain hose, and wiring do not
touch any exposed terminals of
the dishwasher wiring.
Failure to follow these
instructions can result in death or
electrical shock.
Keep cardboard shipping base or
plywood under dishwasher until It Is
Installed, or slide dishwasher onto
cardboard or hardboard before
moving If across the floor.
The cardboard or hardboard will
help protect floor covering when
dishwasher Is moved across the
floor during Installation.
Make sure this clip stays
1
attached to access panel.
■ Remove the 4 screws attaching
access panel and toe panel to dish
washer using a 1 /4" hex socket, nut
driver or Phillips screwdriver. Remove
access panel and toe panel. Make
sure that grounding clip stays
attached to access panel. Set panels
aside on a protective surface.
Min.
Cutout
Height
Wheel
Position
(See
Illustration)
Number
Of Turns
To Adjust
Levelers
34" (86.4 cm) 1
9
34-1/8" (86.7 cm) 2
6
34-5/16" (87.2 cm) 3
3
34-1/2" (87.6 cm) 4
0
For additional height:
1. Add shims under the wheels.
2. Turn front levelers. Each turn changes
height by approximately 1/16" (0.T6 cm).
Measure height of cabinet
opening from the front edge of the
underside of cabinet opening to
floor. Check chart for that height
opening. Put the wheels in the
required position.
Loosen and then turn front levelers
the number of times indicated in
the chart. The dishwasher should
be installed as level as possible
from front to back.
To prevent damage to floor covering,
tilt dishwasher backwards on wheels
when moving across floor.
Wa Latch
dishwasher
door. Push
dishwasher
into place,
sliding drain
hose through hole cut in cabinet
opening.
Do not kink power supply cable
between dishwasher and cabinet.
If dishwasher Is equipped with a tub
collar and does not fit In cabinet
opening or cabinet opening Is less
than 24 Inches (61 cm) wide,
partially pull dishwasher out of
cabinet. Start at one side of
dishwasher and pull tub collar off of
dishwasher. Completely remove tub
collar and save. Push dishwasher
back into cabinet opening.
Page 7
