Water
requirements
All solder connections must be
made before the water line Is
connected to the dishwasher to
prevent damage to Inlet valve.
Do Not solder within 6 Inches
(15 cm) of the Inlet valve. The
plastic part of the Inlet valve could
be damaged.
The hot water line to the
dishwasher must provide between
15-120 psi (103-827 kPa) water
pressure.
The hot water heater should be set
to deliver 120“F (49°C) water
temperature to the dishwasher for
best results.
Use 3/8" (9.5 mm) O.D. copper
tubing or 1/2" piastic tubing
minimum inlet line. Dishwasher inlet
valve has 3/8" internal pipe thread.
Water line
connection
Awarning
>4
Electrical Shock Hazard
Disconnect electrical power at the
fuse box or circuit breaker box
before installing dishwasher.
Failure to follow this instruction
can result in death or electrical
shock.
1I Disconnect the electrical
power supply. Put on gloves and
safety glasses.
cabinet
wall
6"
(15.2 cm)
water supply
pipe
alternate
water-line
locations
(10.2 cm)
2-1/2".
(6.4 cm)
I Cut a 1 /2" (1.3 cm) minimum
hole in cabinet rear wall or floor for
water line.
Oa Rough in water line through
the 1/2" (1.3 cm) minimum hole to
dishwasher cabinet opening.
■•a Install a shutoff valve
in the water line where it
can be easily used.
wa Flush water line into a bucket
to get rid of any particles that may
clog the inlet valve. Turn the
shutoff valve to "OFF" position.
6 a Check that there are no
sharp bends or kinks in the water
line that may restrict the water
flow.
Page 5
