21. Insert the new pump into the module
body. Rotate the pump until the pump
inlet nipple registers with the port in the
bottom of the body and press down. At
this point, the pump should no longer be
able to rotate.
22. Mark this location on the pump and
module body, and then remove the
pump.
23. Reinstall the new pump aligning the
marks on the pump and body, as you do
slide the brass ground terminal between
the pump and the module body trapping
it in place. Ensure that the pump inlet is
aligned with the port in the bottom of the
body.
24. Slide the tie strap around the top of the
pump until the anchor end contacts
the side of the module body. Mark this
location with a line going down from the
top edge approximately 3/8”.
