32
ASSIGNING STATIONS TO THE DIAL
BY VOICE FEATURE
This program allows stations to be assigned to a voice dialer (optional equip-
ment required) to dial a personal speed dial number.
Open customer programming and follow the instructions below.
NOTE: This feature requires optional software and/or hardware. Please see your
service and installation company for details.
PROGRAM KEYS
UP & DOWN - Used to scroll through options.
KEYPAD - Used to enter selections.
SOFT KEYS - Move cursor left and right.
SPK - Used to store data and advance to next program.
HOLD - Used to clear previous entry.
ACTION DISPLAY
1. Press TRSF and then dial 216 [3551]VOICE DIAL
Display shows USER 1:NONE
2. Dial voice dial number (e.g., 3552) [3552]VOICE DIAL
OR use UP and DOWN to make selection USER 1:NONE
Press right soft key to move cursor
3. Dial user number (1–7/1–5) dependent on [3552]VOICE DIAL
number of users allowed via MMC 215 USER 5:NONE
OR press UP or DOWN to make selection
Press right soft key to move cursor
4. Dial station number (e.g., 205) [3552]VOICE DIAL
OR
Press UP or DOWN to make selection
USER 5:205
Press right soft key to return to step 3 to
continue with entries
5. Press TRSF to store and exit
OR press SPK to store and
advance to next MMC
CUSTOMER SET RELOCATION
[RELEASE 3 AND 4 ONLY]
This program is used to swap information associated with two stations. All as-
signments such as trunk ring, station group, station COS, station speed dial
etc. will follow this program. 12 button keysets and 24 button keysets can be
exchanged. Basic 7 button keysets can be exchanged with Basic 7 button key
sets. Single line stations numbers can be exchanged. If incompatible set types
are selected the DCS system will provide an ERROR: NO MATCH message. 12
button and 24 button key assignments should be taken in consideration when
relocating these type of sets. The table below shows which phones can be
switched with each other.
NOTE: In order to use this program it must first be activated by a technician.
Please see your installing company to have this done if you wish to use this
program.
CUSTOMER SET RELOCATION ALLOW TABLE
PROGRAM KEYS
UP & DOWN - Used to scroll through options.
KEYPAD - Used to enter selections.
SOFT KEYS - Move cursor left and right.
SPK - Used to store data and advance to next program.
HOLD - Used to clear previous entry.
ANS/RLS - Used to select ALL.
33
L/SNTB721CSB21DCL42CSB42DCLMOAMB46
L/SSEYONONONONONONON
NTB7ONSEYONONONONONON
21CSBONONSEYSEYSEYSEYONON
21DCLONONSEYSEYSEYSEYONON
42CSBONONSEYSEYSEYSEYONON
42DCLONONSEYSEYSEYSEYONON
MOAONONONONONONSEYON
MB46ONONONONONONONSEY
