Produtos da Marca Dell

Back to Contents Page

 Front USB Panel

Dell™StudioXPS™7100ServiceManual

Removing the Front USB Panel

Replacing the Front USB Panel



Removing the Front USB Panel



1. Follow the instructions in Before You Begin.



2. Remove the computer cover (see Removing the Computer Cover).



3. Remove the front bezel (see Removing the Front Bezel).



4. Disconnect the front USB panel cables from the system board connector F_USB2 (see System Board Components).



5. Remove the screw that secures the front USB panel to the front panel.



6. Slide the front USB panel down to release the clamps from the front panel and pull it away.

WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best

practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.

WARNING: To guard against electrical shock, always unplug your computer from the electrical outlet before removing the cover.

WARNING: Do not operate your computer with any cover(s) (including computer covers, bezels, filler brackets, front-panel inserts, etc.)

removed.

CAUTION: Onlyacertifiedservicetechnicianshouldperformrepairsonyourcomputer.DamageduetoservicingthatisnotauthorizedbyDell™

is not covered by your warranty.

NOTE: Make note of the routing of all cables as you remove them so that you can re-route them correctly when installing the new front USB panel.

CAUTION: When sliding the front USB panel out of the computer, be extremely careful. Carelessness may result in damage to the cable

connectorsandthecableroutingclips.

front USB panel clamp slot

clamps (2)

front USB panel

screw