Produtos da Marca Chery

2.2.35. Seat belt: Check its damage;

2.2.36. Trial driving: Check the display status of combination instrument, the working condition

of four-door regulator, and the function of the steering, braking and gear shifting

mechanisms, pay attention to the abnormal sound from the engine and body, and examine

and repair it, if necessary;

2.2.37. Look around the vehicle, and wash it if there is no abnormal symptom, then deliver the

vehicle to its owner.

2.3. Standard 30,000 KM maintenance work procedure

2.1.1. Receive the vehicle to be maintained, wear the “four-piece series” (seat cover, steering

wheel cover, shift lever cover, driver’s foot pad) on the vehicle, drive the vehicle to the

lifting jack, and support the vehicle;

2.1.2. Prepare for the related tools and special devices;

2.1.3. Wear the left and right fenders protective covers and front protective covers on the vehicle

to be maintained;

2.1.4. Replace the engine oil, and oil cleaner(refer to the replacement above-mentioned in this

manual);

2.3.5. fuel filter: refer to the replacement above-mentioned in this manual;

2.3.6. All joints of fuel system: Check its ageing, damage, abnormal looseness or friction;

2.3.7. Check transmission oil: Check the leakage of transmission oil viewing from the engine

compartment; and then lift up the vehicle and check the leakage of transmission oil viewing

from the bottom of vehicle;

2.3.8. Check the free travel of clutch,and regulate it, if necessary;

2.3.9. Check the oil/fluid: Check the levels of brake fluid, antifreeze fluid, glass cleaning fluid

and power steering oil, and the leakage of the related pipelines;

2.3.10. Battery: Check the electrolyte level, and refill the distilled water if necessary (the

maintenance-free battery exclusive);

2.3.11. Wiper and cleaning equipment: Check its working condition;

2.3.12. Check the door lock, hinge and stopper: Check the working condition of all door locks,

hinges and stoppers, and appropriately add the lubrication oil if there is abnormal sound or

the resistance is big;

2.3.13. Check the air cleaner: Clean the element (with the high-pressure air), and replace it, if

necessary;

2.3.14. Check the dislocation or damage of the dust cap of constant velocity joint;

2.3.15. Check the damage of steering tie rod end and its dust cap;

2.3.16. Ball pin: Check its looseness and scratch;

2.3.17. Check the thickness of brake lining/shoe, and replace it, if necessary. The standard

thickness of front brake lining is 10 mm, with the serviceability limit of 3 mm, and the

remaining thickness while the brake lining thickness limit shall not be less than 3 mm; and

the standard thickness of rear brake lining is 5 mm, with the serviceability limit of 1 mm,

and the remaining thickness while brake lining thickness limit shall not be less than 1 mm;

2.3.18. Brake disc/drum: Check its working condition, the damage, and replace it, if necessary;