Produtos da Marca Chery

2.2.19. Brake hose: Check its ageing and damage;

2.2.20. Brake pipe: Check its damage, corrosion and the leakage of all joints;

2.2.21. Check the suspension components: Check its abnormal looseness or friction, damage, and

the working condition;

2.2.22. Rear shaft rubber hinge: Check its damage;

2.2.23. Control arm rubber sleeve: Check its damage;

2.2.24. Check the brake system: Check the brake fluid level, the status of all connecting pipes,

leakage and damage, the working condition of the system, and repair or replace it, if

necessary;

2.2.25. Check the A/C system: clean the element (with the high-pressure air), check its pressure

(it is different according to the various working conditions, etc, and the reference value

while idling is:low pressure: 2.5 - 3.0 Bar; high pressure: 15 - 17 Bar), the leakage,

abnormal sound, odor, and the working condition;

2.2.26. Check tire (including spare tire): Check the depth of tire pattern, which the depth of tire

pattern shall not be less than 1.6 mm; regulate the air pressure of tire: 230kPa for front

wheel, and 210 kPa for rear wheel; and check the wheel bolt tightening torque

(110±10Nm);

2.2.27. Check the chassis bolt: Check the chassis bolts one-by-one with a torque wrench, and

tighten it to the specified torque if loose ;

2.2.28. Toe-in value and camber angle: Check the toe-in value, camber angle, and adjust it if

necessary (refer to the parameters above for the adjustment);

2.2.29. Check the spark plug: Check whether the spark plug has the carbon deposits, ablation

symptom, etc, and replace it if necessary (the service life of a spark plug is in general

30,000 KM);

2.2.30. Wedge belt: Check its tension, and regulate or replace it if necessar.Refer to the “Timing

belt”in the Standard 30,000 KM maintenance work procedure for the tension requirement

after regulating;

2.2.31. Check the engine while idling: Check the working condition of the engine while

idling,check the working condition of electronic fuel injector parameters and exhaust, and

adjust it if necessary;

2.2.32. Exhaust system: Check its leakage and damage, and regulate or replace it if necessary;

2.2.33. Lower the vehicle, and take off the “four-piece series” and the protective covers of left

and right fenders and the front protective cover;

2.2.34. Check the lighting, warning flasher devices, horn: Check its working condition;