5. Use a 10# open end wrench to loosen the adjusting
bolt of steering pump bracket, and then pull the steering
pump upwards to loosen and take off the belt.
6. Use a 10# sleeve to loosen the connecting bolt of
steering pump and compressor bracket, pull out harness
connector, and then dismount the steering pump
assembly.
II. Overhaul
Steering pump can not be repair, if such failure as abnormal noise or oil leak exists, replace the
assembly.
III. Installation of the Steering Pump
1. Follow the order adverse to that of disassembly to install.
2. After installation of steering oil pump, duly adjust tightness of belt through adjusting bolt.
3. After power steering pump is properly installed, refill with special steering pump oil, and then
bleed air for the power steering pump after the engine starts.
4. Air bleeding method:
4.1 Hoist the vehicle to let its front wheels leave ground.
4.2 Turn the steering wheel left and right to the ends (duration for each time should not exceed 5s,
otherwise, the power steering pump is likely to be burnt out) until the oil pump does not make
sound. Note that oil storage kettle should not be lack of steering pump oil.
Note: when dismounting the
steering pump, please block the oil
pipe joint with clean cotton cloth.
