Using the J 42098 rotate the crankshaft counter clockwise to 3 degrees BTDC, allowing the timing belt to slide on
the J 42069-30.
8.
Install the lower idler pulley and spacer with the timing belt.9.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that
application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are
identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint
surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener.
Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and
systems.
Install the lower idler pulley bolt. Tighten the lower idler pulley bolt to 40 Nm (30 lb ft).10.
6 of 16
